Hi. I'm new to the forum and Zuma itself.
I have a 2009 Zuma 125 and I'm prepping my bike for winter and did the oil change, Sta-Bil, etc. I also changed my spark plug. My problem/concern is that when I screwed the spark plug back in and proceeded to put the spark plug cover back on, the rubber part doesn't look flush to the engine on one side. I don't remember how it looked before I took it out, I should've made a note of that before taking the rubber part off.
I couldn't find a good photo of the spark plug cover anywhere. I'll attach a photo of what I mean. Let me know if it's nothing to worry about or if I should attempt for the 4th time to see if I can get it flush. I don't want junk or water flying in there if you know what I mean. I did try to push the cover in with just a bit more force in case I thought it wasn't completely in but it wont go any further. Unless you think I should put MORE force and and there's supposed to be a click to it.
Also if you have a photo of your spark plug cover on at the side angle, mostly the side where the exhaust is, I'd really appreciate that. As I'm writing this, I just thought to myself, maybe I should just start the bike to see if it fires up right, unless that's a bad idea.
| Attachments: |
|
File comment: Looking from the side with No exhaust No exhaust side.jpg [ 932.17 KiB | Viewed 909 times ] |
|
File comment: Looking from the side with the exhaust. 20171105_102255.jpg [ 910.71 KiB | Viewed 909 times ] |